Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Redondo Beach?
A chimney liner replacement in Redondo Beach typically runs $2,400 to $4,800, and a partial chimney rebuild usually lands between $4,200 and $9,500. Full rebuilds above the roofline push past $12,000 when the crown, flashing, and several courses of brick all need replacement at once. Most single-story Beach Cities homes fall in the middle of those ranges, and the exact figure comes down to flue length, liner material, and how much of the existing masonry is still sound.
We give written, line-item estimates before any work starts, so you know what you’re paying for before a single tile comes down. Call (866) 632-1088 to schedule yours.
Chimney Liner & Rebuild Cost Breakdown (2026)
Here’s how the work prices out in the Redondo Beach market this year. These are real installed ranges, not starting-at teasers, and they include labor, materials, and haul-away.
| Line Item | Typical Range (Installed) |
|---|---|
| Stainless steel liner (6″ flex, per foot) | $32 – $55/ft |
| Full liner replacement, single-story home (15 – 25 ft flue) | $2,400 – $4,200 |
| Full liner replacement, two-story home (25 – 40 ft flue) | $3,600 – $5,800 |
| Insulated liner (adds safety and draft performance) | +$400 – $900 |
| HeatShield flue resurfacing (per flue, restore without full reline) | $1,600 – $3,200 |
| Crown repair or rebuild | $600 – $1,800 |
| Partial rebuild (above roofline, 3 – 8 courses of brick) | $4,200 – $9,500 |
| Full chimney rebuild (roofline to cap) | $9,000 – $15,000+ |
| New chimney cap (Gelco or Copperfield) | $250 – $650 |
| Flashing repair or replacement | $400 – $1,100 |
| Damper replacement | $350 – $800 |
Two things push a job toward the top of those ranges: flue length and material choice. A long flue in a two-story home uses more liner, and the labor to feed it down a tight, offset chimney adds up. On the material side, a standard single-wall DuraFlex liner sits at the low end while an insulated or heavier-gauge setup costs more but performs better on draft and protects against the cool, damp marine air that works its way into unlined flues here in Redondo Beach. We use DuraFlex, Olympia Chimney, and HeatShield because those are the products we’d spec in our own homes, and we’ll walk you through the trade-offs rather than quietly upgrading you.
What usually separates a repair from a rebuild is the state of the masonry itself. A cracked or spalling flue interior behind an intact chimney is a liner job. Crumbling mortar joints, a leaning stack, or brick that’s gone soft from years of salt air means rebuilding. We diagnose which one you’re facing before quoting, and where it’s an option we lean on HeatShield flue resurfacing to restore a damaged flue without tearing the chimney apart.
What Affects Chimney Liner & Rebuild Pricing in Redondo Beach
Redondo Beach is hard on chimneys in ways a lot of price guides skip. The salt air off the coast, the marine layer that keeps flues damp through the cooler months, and the fact that many of the homes here were built between the 1940s and 1960s with original clay-tile liners all shape the final number. Here’s what actually moves the price:
- Flue length and configuration. A straight 15-foot flue in a single-story home is a straightforward job. An offset or angled flue in a two-story house off Catalina Avenue takes more labor to line and adds several hundred dollars. Every extra foot of liner is billed, so height matters directly.
- Original liner condition. If the existing clay tiles are cracked, misaligned, or missing, we can’t just slide a new liner past them – those have to be addressed, sometimes relined, sometimes resurfaced with HeatShield. Solid tiles mean a cleaner, cheaper install.
- Liner material and gauge. DuraFlex stainless liners in a standard gauge sit at the bottom of the range. Heavier-gauge or insulated liners cost more but hold up better against the coastal moisture that degrades cheaper materials quickly.
- Masonry damage from salt air. Homes in the Avenues and along the bluffs see more spalling and mortar erosion than inland properties. That’s a rebuild conversation versus a liner conversation, and the two price very differently.
- Appliance type. A wood-burning fireplace, a gas insert, and a furnace flue each need a different liner rated for the temperature and byproducts involved. A high-efficiency gas appliance often needs a full stainless reline because the old clay flue can’t handle the lower flue temperatures and acidic condensation.
- Roofline access and height. A steep or tile roof takes longer and more care to work on safely than a low-pitch composition roof, and that labor is real. A roof that’s tricky to stage adds a couple hundred dollars, never a hidden surprise – we quote it upfront.
One local pattern worth knowing: in the older tracts near the North Redondo border and around Beryl Heights, we regularly find clay flues that looked fine from the firebox but had hairline cracks near the top that only show up on camera. That’s not an upsell, it’s why we scope every flue before quoting a liner or rebuild. It’s the difference between fixing the right thing and guessing. For a closer look at how our liner and rebuild work fits together, the main Chimney Liner & Rebuild in Redondo Beach page walks through the full process.
How to Save on Chimney Liner & Rebuild
There’s no discount that beats doing the right repair once, but there are real ways to keep the bill down without cutting corners:
- Fix the flue before the masonry. If HeatShield resurfacing can restore a cracked flue instead of a full reline or rebuild, that saves you thousands. We check that path first because it protects the chimney without a teardown.
- Insulate one time. Paying a few hundred extra for an insulated liner now saves you from a second liner replacement years down the road. The coastal damp here is unforgiving of bare liners.
- Bundle the sweep and the repair. When we’re already on the roof cleaning and inspecting, the repair is cheaper than a separate trip. We pair chimney work and dryer vent cleaning in the same visit, so one call covers both fire hazards in the house.
- Address the crown early. A $600 to $1,800 crown repair now prevents the water damage that turns into a $9,000 rebuild later. Small maintenance protects the big investment.
- Get a written, line-item estimate. A vague lump-sum quote hides the details. We itemize every part and product so you can compare fairly.
Free estimates are the simplest money-saver of all – call (866) 632-1088 and we’ll scope the flue, photograph what we find, and price it out in writing before anything begins.
Why Redondo Beach Chimneys Cost What They Do
It helps to understand the local climate’s role. Redondo Beach sits close enough to the water that chimneys here deal with steady humidity and salt-laden air most of the year. That combination attacks mortar and corrodes cheap liners faster than the dry inland heat of, say, the Inland Empire. A liner that might last decades in a desert climate can fail sooner here if it isn’t the right grade and properly insulated. That’s not a scare tactic, it’s the reason we spec DuraFlex and Olympia Chimney products rather than the thinnest option on the shelf.
The housing stock matters too. Many Redondo Beach homes date to the postwar building boom, when clay-tile flues were standard and capped at a size that works for a wood fire but not always for a modern high-efficiency gas appliance. When someone swaps in a new furnace or water heater, the existing flue often can’t keep up, and that’s when a reline becomes necessary. We see this especially in the older streets north of Torrance Boulevard. If you’re heading into a furnace or appliance upgrade, get the flue checked first so you’re not surprised halfway through the project.
We also handle the chimney cap and vent components in-house, fitting Gelco and Copperfield caps and using Famco dryer vent products when we’re on the roof doing vent work. That means when a cap is missing and rain has been running down the flue for years, we can fix the source and the damage in one appointment. You’ll find the same approach on our home page and throughout our Redondo Beach service area.
FAQs – Chimney Liner & Rebuild Cost
How much does a chimney liner cost in Redondo Beach?
A full chimney liner replacement in Redondo Beach costs $2,400 to $5,800 installed, with most single-story homes landing between $2,400 and $4,200. The range depends on flue length, liner material, and whether the old tile needs addressing first. Call (866) 632-1088 for an exact quote – estimates are free.
Is it cheaper to repair or rebuild a chimney?
Repair is almost always cheaper when the damage is contained to the flue. HeatShield resurfacing or a new liner runs $1,600 to $4,800, while a partial rebuild costs $4,200 to $9,500 and a full rebuild can exceed $12,000. We tell you honestly which one your chimney actually needs. Call (866) 632-1088 and we’ll diagnose it on site.
Can you replace a chimney liner without rebuilding the chimney?
Yes, in most cases. A stainless DuraFlex liner slides down the existing flue and restores safe venting without touching the exterior masonry, so you keep the chimney you have. If the flue itself is damaged, HeatShield resurfacing can restore it first. Call (866) 632-1088 to find out which path fits your chimney.
How much does chimney crown repair cost in Redondo Beach?
Chimney crown repair runs $600 to $1,800 depending on the size and condition. That’s money well spent, because a failed crown lets rain into the flue and drives the water damage that leads to far bigger rebuild bills. Call (866) 632-1088 to get your crown looked at before the wet season.
Can you come out today for an estimate?
We schedule free estimates quickly, and many Redondo Beach homeowners get an appointment within a few days. Same-day service depends on the day’s route, so call (866) 632-1088 to check the soonest opening and lock in your written quote.
What’s Included in Our Liner and Rebuild Estimates
A fair price is only half the story; knowing what’s inside it is the other half. Every estimate we write covers the flue scope and inspection, the specific liner product and gauge we’ll install, the cap and flashing work, and haul-away of old materials. You’ll see DuraFlex or Olympia Chimney named directly on the quote rather than a generic “stainless liner,” because you should know exactly what’s going into your home. If a rebuild is the honest answer, the estimate breaks out the brickwork, the crown, the flashing, and the cap separately so you can see where the money goes.
We do the whole job with one company: diagnosing, cleaning, and repairing, with no handoffs between vendors. That single-contractor accountability is why we pair chimney repair with dryer vent cleaning as a natural set – two of the leading fire hazards in a house handled by the same team, using Famco vent components and the same brands we trust on the chimney side. It’s one call instead of two, and one crew that knows the whole system.
If you’re comparing quotes and one looks unusually low, ask what liner material and gauge it includes and whether the flue gets inspected on camera first. That’s where cheap quotes hide their savings, and it’s exactly where a Redondo Beach chimney pays for it later.
Ready to know what your chimney actually needs? Call (866) 632-1088 for a free, written estimate from the team at Chimney Sweep Redondo Beach. We’ll scope the flue, show you the products, and price the job with no guessing.
Pricing reflects the Redondo Beach market as of 2026. Chimney Sweep Redondo Beach offers free estimates – call (866) 632-1088.
What Our Customers Say
"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
- Brandon Tran"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Bethany Hayes"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
- Maya Gupta