Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Mar Vista, CA
Chimney repair in Mar Vista is shaped by one fact more than any other: most of the housing stock here was built between 1940 and 1965, and the original clay-tile flue liners and masonry stacks are now 60 to 80 years old. We see cracked crowns, spalled brick, and failed flashing on stucco and wood-frame homes from the Mar Vista Recreation Center area out to Grand View Boulevard. If you’re noticing water stains near the fireplace, crumbling mortar on the roof, or smoke backing into the living room, call (866) 632-1088 and we will assess the chimney itself, camera first, before recommending anything.
Why Mar Vista Homes Are Different
Mar Vista’s mid-century tract homes and dingbat apartments were largely built without the wood-burning-heating culture you find in colder regions. Fireplaces here are mostly decorative, tucked into small living rooms, and spent decades unused. That means the masonry and flue liners often look intact from the outside while failing quietly from decades of marine-layer moisture and the occasional hot Santa Ana smear.
The coastal air near the 90066 ZIP keeps humidity higher than inland Los Angeles, so brick and mortar weather slowly but constantly. During Santa Ana wind events, that same dry, gusty airflow pushes debris, leaves, and bird nesting material into uncapped flues. We routinely find that the chimney hasn’t been swept in thirty years, not because anyone was negligent, but because no one ever used it hard enough to notice a problem. The repair work in Mar Vista is less about heavy creosote and more about restoring aging masonry and bringing those original clay-tile liners back to safe condition.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Main Mar Vista Services
Most calls from Mar Vista homeowners fall into two categories: a fireplace that hasn’t been cleaned in years and needs a proper sweep, and a dryer vent that has never been touched since the appliance was installed. We handle both.
Chimney Sweep in Mar Vista
A sweep in Mar Vista usually means cleaning a decorative fireplace that has sat dormant through years of coastal humidity. The flue gets brushed top to bottom, the smoke chamber is cleared of bird nests and debris that Santa Ana winds push in, and the firebox is vacuumed clean. For homes near Venice Boulevard where stacked flue chases between dingbat units share a masonry stack, our technicians identify which flue belongs to which unit before work begins. Full details and scheduling are on our Chimney Sweep in Mar Vista page.
Dryer Vent Cleaning in Mar Vista
Dryer vents in Mar Vista’s older homes are often short and hidden behind stucco walls, which makes people assume they’re fine. They rarely are. Lint accumulates at the wall cap, inside the duct, and around the dryer connection, reducing airflow until the dryer runs hot and the risk of a lint fire climbs. We clean the full run, cap to wall, and use Famco hardware when the wall cap or transition duct needs replacement. See our Dryer Vent Cleaning in Mar Vista page for what’s involved.
Chimney Repair in Mar Vista
Chimney repair in Mar Vista often comes down to decades of slow moisture intrusion. The original masonry stacks on 1940s-to-1960s homes near Grand View and around the Mar Vista Recreation Center weren’t built with modern crown overhangs or high-performance flashing, and the coastal air in 90066 has spent sixty years working into the mortar joints. Cracks in the crown let water soak the brick, spalling follows, and then the flashing at the roofline starts to separate. This is our primary service for good reason: a chimney that’s silently deteriorating is a structural and fire-safety liability. If you need a fuller look at how we approach this work, see our Chimney Repair hub.
Chimney Cap Installation
Signs you need it
You hear birds in the chimney, find nesting material in the firebox, or get rain dripping down the flue during winter storms off the Pacific.
What it costs in Mar Vista
A chimney cap installation in Mar Vista typically runs $180 to $340 depending on flue size and roof access.
How we do it
We measure the flue tile, select either a Gelco or Copperfield cap matched to the opening, secure it with mechanical fasteners, and seal the edges against water entry.
Chimney Liner Installation
Signs you need it
Your 1940s or 1950s clay-tile liner is cracked, flaking, or has gaps visible during a camera scan, and smoke or carbon monoxide is leaking into wall cavities.
What it costs in Mar Vista
A chimney liner installation in Mar Vista typically costs $2,500 to $5,000 depending on the flue height and whether an insulation wrap is required.
How we do it
We run a camera through the old flue to document its condition, then draw a DuraFlex stainless steel liner down the chase and reconnect the appliance to the new liner with a proper flue connector.
Chimney Flashing Repair
Signs you need it
You see a water stain on the ceiling near the fireplace after rain, or the sheet metal flashing around the chimney at the roofline is lifting, rusted, or patched with old roofing cement.
What it costs in Mar Vista
Chimney flashing repair in Mar Vista typically runs $350 to $750 depending on how much of the existing flashing must be cut out.
How we do it
We remove the damaged flashing, install new step and counter flashing lapped under the shingles and over the masonry, and seal every joint with a weather-rated polyurethane sealant.
What Chimney Repair Costs in Mar Vista
| Item | Typical range in Mar Vista |
|---|---|
| Chimney inspection with camera | $175 – $350 |
| Chimney cap installation | $180 – $340 |
| Chimney flashing repair | $350 – $750 |
| Chimney liner installation | $2,500 – $5,000 |
How long does a chimney liner last in Mar Vista’s climate?
A stainless liner installed in Mar Vista will typically outlast the masonry around it, often 25 years or more. The coastal humidity affects brick and mortar far more than the liner itself, so the liner usually becomes the most durable part of the chimney.
Can you repair a cracked clay tile liner without replacing the whole chimney?
Yes. In many Mar Vista homes we use HeatShield, a ceramic sealant that restores flue tiles by filling cracks and resurfacing them, extending the life of the original liner without tearing out the masonry. The work is done with a camera before and after so you see exactly what was repaired.
Brands We Service in Mar Vista
We use DuraFlex stainless liners, Gelco caps, and Copperfield components because these are the products working pros specify on their own houses. HeatShield lets us restore Mar Vista’s original clay-tile flues instead of replacing them. The parts we install are widely serviced, so you’re never stuck with a proprietary orphan system. Learn more on our brands page.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Mar Vista, CA
| Service | Typical range in Mar Vista |
|---|---|
| Chimney sweep (inspection included) | $169 – $240 |
| Dryer vent cleaning | $100 – $150 |
| Chimney inspection with camera | $175 – $350 |
| Chimney cap installation | $180 – $340 |
| Chimney flashing repair | $350 – $750 |
| Chimney crown repair | $450 – $950 |
| Chimney liner installation | $2,500 – $5,000 |
| HeatShield liner restoration | $1,500 – $3,000 |
Two things push chimney repair prices up in Mar Vista: first, the age of the original masonry, which means we often find hidden damage once the crown or flashing is opened up. Second, roof access on two-story stucco homes and tight dingbat alleyways slows the work and requires more ladder setup. You get a flat price before any work starts, and that price does not change unless you approve a written change order after we show you camera evidence.
Neighborhoods We Serve in Mar Vista
We work throughout the 90066 ZIP, from the residential blocks around the Mar Vista Recreation Center and Grand View Boulevard down to the dingbat apartments near Venice Boulevard and Centinela Avenue. Our service area covers the full span of Mar Vista’s housing stock, and most appointments are scheduled within a week of your call.
- Mar Vista Recreation Center area
- Grand View Boulevard corridor
- Venice Boulevard and Centinela blocks
- Mar Vista Gardens
- North Westdale border blocks
Service Area – Cities Near Mar Vista
We regularly take chimney repair and cleaning calls from neighborhoods just outside Mar Vista, including Playa Vista, CA, Playa del Rey, CA, Morningside Park, CA, and Crenshaw, CA. If your address sits near the border, call and we will confirm coverage.
Serving Mar Vista, CA – Our Local Coverage Area
We’re based in the Mar Vista area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Mar Vista
Most Mar Vista appointments are scheduled within five business days of your call. If you have an active leak or a chimney fire has just occurred, call (866) 632-1088 and we will triage the situation and get someone out as early as the schedule allows.
Some Mar Vista condo associations and dingbat apartment ownership groups require approval before rooftop work or any exterior change like a new chimney cap. We can provide a written scope of work and photos for your HOA board if needed, and we follow Los Angeles building code for all liner and flashing installations.
Yes. One call covers both. If you’re in Mar Vista and want a fireplace sweep and a dryer vent cleaning, we schedule them together and you get one arrival window, one technician team, and one invoice. It’s the most efficient way to knock out both major household fire-hazard sources.
If you need a chimney repair assessment or a full sweep in Mar Vista, call (866) 632-1088 for a free estimate. We will tell you what’s actually wrong, show you the camera footage, and quote a flat price before any work starts.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you. The visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Mar Vista Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
- Yolanda Prince"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
- Oscar Ramirez"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
- Brandon Tran